Menu
EUR

Finishing your camper with needle felt

Finish your camper with needle felt from Geluidsisolatie Deal. Give your interior a sleek look, easy to install, and available in 6 colours.

Do you want to finish the walls, ceiling, door panels or wheel arches of your campervan neatly? With full stretch needle felt you give the interior of your van conversion a sleek, calm finish. The material easily follows curves and is therefore suitable for both flat and curved parts.

  • 4-way stretch: follows curves and bulges without creasing easily.
  • Neat cut edges: the material does not fray, so you can finish edges tightly.
  • Different versions: choose from self-adhesive or non-adhesive needle felt and several colours.

What is needle felt for your campervan?

Needle felt is a thin and sturdy covering material made of polyester fibres. The fibres are mechanically bonded together with thousands of needles, without weaving or knitting the material. As a result it does not fray when cut and you can easily cut it to size for the different parts of your campervan interior.

Our stretch needle felt is made from recycled PET and has 4-way stretch. The material can therefore be stretched in several directions. This is especially handy when covering round and irregular parts, such as wheel arches, window pillars and curved wall sections.

Needle felt is intended as a finish and not as thermal insulation or complete sound insulation. Do you also want to make your campervan warmer and quieter? Then combine it with the right insulation and, where necessary, sound deadening material behind the finish such as a vibration damping sheet.

Why cover your campervan with needle felt?

Needle felt gives bare sheet steel, wall panels and other interior parts a neat finish. At the same time, the material helps make hard surfaces less vulnerable and acoustically less reflective.

Neat, finished look

Thanks to the stretch you can cover many curves and other shapes without unnecessary seams. This gives the interior of your campervan a calm finish reminiscent of the upholstery of a factory interior.

Less direct contact between indoor air and cold metal

When bare metal is covered, humid indoor air no longer comes into direct contact with the metal surface. However, needle felt is not a vapour barrier and does not prevent moisture or rust problems on its own. For a good campervan build-up, suitable insulation, ventilation and treating existing rust remain important.

Less reverberation in the interior

The soft surface absorbs part of the sound reflections in the campervan and can therefore help reduce a hollow sound. Want to mainly tackle road noise and impact noise? Then combine needle felt with sound deadening sheets and suitable insulation material.

Protection of interior parts

Needle felt forms a soft finishing layer on, for example, wheel arches, wall panels and cabinet parts. This means these surfaces are better protected against light scratches and scuffs during daily use.

Properties of our needle felt

Property Explanation
4-way stretch Stretches in several directions and therefore easily follows curves.
Does not fray Cut edges stay neat and do not need to be hemmed.
UV resistant Suitable for use in vehicle interiors where sunlight can enter.
Fire class Bfl-s1 According to EN 13501-1.
Antistatic Attracts dust and hair less easily.
Recycled PET Made from polyester fibres from recycled PET.
Sound absorption αw 0.15.
6 colours Anthracite, beige, blue, light grey, mouse grey and black.

Which needle felt do you choose for your campervan?

For covering your campervan you make two important choices: self-adhesive or non-adhesive and standard or premium. Which version is best depends mainly on the shape of the part and how visible the covering will be.

Self-adhesive needle felt

The self-adhesive variant has an adhesive layer with a protective film. This means you do not need separate spray adhesive. That makes this version especially practical for smaller and relatively flat parts, such as cupboards and door panels. The adhesive layer limits the stretch of the material, so strongly curved parts are harder to cover.

Non-adhesive needle felt

You glue non-adhesive needle felt yourself with suitable spray adhesive. This takes a little more work, but you keep more of the stretch of the material. This version is therefore usually the best choice for larger surfaces and parts with many curves, such as walls, ceiling and wheel arches.

Standard or premium needle felt?

Standard needle felt is suitable for a sleek, functional finish and for the applications on this page. It is a good choice when you mainly want a neat finish at a keener price, for example for a cargo area, cupboard interior or wheel arch.

Premium needle felt is applied in the same way, but according to the stated product specifications has a higher pile weight of approximately 450 grams compared with approximately 300 grams for standard needle felt. As a result the material looks and feels fuller. Premium is especially interesting for visible work in the living area, such as walls, ceiling and door panels.

Needle felt available in 6 colours

Match the finish to the rest of your campervan interior. The needle felt is available in:

  • Anthracite
  • Beige
  • Blue
  • Light grey
  • Mouse grey
  • Black

How much needle felt do you need for your campervan?

For a fully covered cargo space – walls, ceiling, rear doors and wheel arches, excluding the cab – you can use the quantities below as a starting point. The calculation assumes non-adhesive needle felt with a width of 206 cm.

Van size Needle felt High Temperature spray adhesive
L1H1 approx. 11 metres approx. 9 cans
L1H2 approx. 12 metres approx. 10 cans
L2H2 approx. 13 metres approx. 10 cans
L3H2 approx. 15 metres approx. 12 cans
L4H2 approx. 16 metres approx. 13 cans
L3H3 approx. 17 metres approx. 14 cans
L4H3 approx. 17 metres approx. 14 cans

These quantities are based on the Fiat Ducato, Citroën Jumper and Peugeot Boxer. The interior dimensions of other makes may differ for the same designation, for example L2H2.

Calculating for a different type of van

Does your van have an interior height of up to about 2 metres? Then use the following practical guideline:

(3 × cargo length) + rear door height + 0.8 metres for the wheel arches + 0.5 metres cutting allowance.

Round the result up to whole metres. For the full calculation, adjustments for when you do not cover the ceiling, for example, and the calculation for high vans, see our blog How much needle felt do I need for my campervan?

Tip: preferably order the needle felt you need in one go. A slight colour difference can occur between different production batches.

Fitting needle felt in your campervan

You do not need complicated tools to cover your campervan. With a sharp snap-off knife, tape measure and – for non-adhesive needle felt – suitable spray adhesive, you can cover most parts yourself.

  1. Clean the substrate. Make sure the surface is dry, dust-free and grease-free. Degrease metal and plastic before you start gluing.
  2. Cut the needle felt with an allowance. Keep a few centimetres of extra material all round. You trim the final edges after positioning.
  3. Apply the adhesive. With self-adhesive needle felt you remove the protective film as you apply it. If you are using loose needle felt, follow the processing instructions of the spray adhesive used.
  4. Work gradually from one side. Press the needle felt down calmly and shape the material along curves and corners. This reduces the chance of creases.
  5. Trim the edges neatly. Use a sharp snap-off knife for edges, openings and cut-outs. Replace the blade as soon as it cuts less smoothly.

Note for roof, ceiling and bodywork: metal vehicle parts can heat up strongly in direct sunlight. Therefore use an adhesive that is suitable for the temperatures and substrates of this application.

Ready to cover your campervan?

Choose the colour and version that suit your campervan, calculate how many metres you need and get started on finishing your walls, ceiling, doors or wheel arches yourself.

Frequently asked questions about needle felt in your campervan

Can I stick needle felt directly onto my campervan's sheet steel?

Yes, needle felt can be applied to a suitable, clean and well-prepared substrate. If you also want to thermally insulate the campervan, first determine the right build-up of insulation and wall finish. Needle felt itself is mainly a finishing material and not a replacement for thermal insulation.

Does needle felt prevent rust in my campervan?

No, needle felt is not a rust-preventing layer or vapour barrier. It covers the cold metal surface, but a good build-up, ventilation and moisture control remain important. Always treat existing rust before you finish the campervan further.

Will needle felt make my campervan quieter?

Needle felt can help reduce sound reflections and reverberation in the interior, but is not complete sound insulation. If you want to reduce road noise and vibration further, combine the finish with materials specifically intended for sound deadening and sound insulation.

Do I choose self-adhesive or non-adhesive needle felt?

Self-adhesive needle felt is mainly practical for smaller and relatively flat parts. For large surfaces and parts with many curves, non-adhesive stretch needle felt is usually easier to shape, because the adhesive layer does not limit the stretch.

How many metres of needle felt do I need for my campervan?

That depends on the length and height of your van and on the parts you want to cover. As a guideline, the quantity for the Ducato, Jumper and Boxer sizes mentioned on this page ranges from approximately 11 metres for an L1H1 to approximately 17 metres for an L3H3 or L4H3. Always measure your own vehicle before you order.

Can I order a sample of the needle felt first?

Yes. On the product page you can order a sample to see the colour and texture of the needle felt beforehand.

Choose your language
Choose your currency
€

Recently added

Total incl. tax
0,00
Order for another €75,00 and receive free shipping
0
Compare
Start comparison

This product has been added to your cart